Contact   Imprint   Advertising   Guidelines

Search found 5 matches

Go to advanced search

by blup
Wed Apr 03, 2013 9:17 pm
Forum: Gear Builders
Topic: wetting the lower side in VIP
Replies: 10
Views: 4217

Re: wetting the lower side in VIP

Hey ,thanks for all reactions. Some good ideas here. I will drill more holes, make a small barrier in the infusion mesh and use two suction tubes. I let you all know how it goes, but it will be something for next week, no time this week. I'm doing all this in a basement of a large building, right ne...
by blup
Tue Apr 02, 2013 8:58 pm
Forum: Gear Builders
Topic: wetting the lower side in VIP
Replies: 10
Views: 4217

Re: wetting the lower side in VIP

Well, I will try to answer all questions. The problem is that with the distribution mesh on the top side, the resin is flowing faster on the top side. On the bottom side it's going a bit slower. At the end of the infusion proces, the resin reaches the suction vacuum tube, and is sucked in to the cac...
by blup
Mon Apr 01, 2013 8:47 pm
Forum: Gear Builders
Topic: wetting the lower side in VIP
Replies: 10
Views: 4217

wetting the lower side in VIP

hi, I tried already two times, but i still have a problem wetting the fibers on the underside of the foam core. Here is my stack from bottom to top: rocker table, Mylar sheet, 3 layer of fiber, corecell foam, 3 layer combined with UD carbon, peel ply, plastic infusion mesh, vacuum bag. I use vacuum ...
by blup
Thu Oct 11, 2012 10:56 pm
Forum: Gear Builders
Topic: Strenght and flexibility
Replies: 41
Views: 13918

Re: Strenght and flexibility

That's what I want, but how flexible it should be? Does it need to be stiff in the middle and flexible on both ends, or does it need to be flexible all the way through the board? And how flexible it should be? If I put some weight on it, how far should it bend? and where should it bend? Greetings, B...
by blup
Thu Oct 11, 2012 10:25 pm
Forum: Gear Builders
Topic: Strenght and flexibility
Replies: 41
Views: 13918

Strenght and flexibility

Hi, I'm reading this forum already for some months because I want to make some boards. I found a lot of information on several topics but there is one thing I don't find information. That's why I registered to be able to launch a question. So here it is: What is the desirable strenght and flexibilit...

Go to advanced search