Contact   Imprint   Advertising   Guidelines

Search found 4 matches

Go to advanced search

by andrew bishop
Mon Aug 20, 2012 4:06 pm
Forum: Board Builders
Topic: Can i use masonite for top of vacuum table
Replies: 4
Views: 1801

Re: Can i use masonite for top of vacuum table

have a 5 cfm pump so vacuum no problem found a roll of laminater plastic so going to put over the masonite and use mould wax

Thanks for the help Andrew
by andrew bishop
Sun Aug 19, 2012 8:57 pm
Forum: Board Builders
Topic: Can i use masonite for top of vacuum table
Replies: 4
Views: 1801

Can i use masonite for top of vacuum table

Going down this route as the clear perspex type of material I got hold of tuns out to be styrene based and melts with polyester resin so wondered if I can use Masonite I think called hardboard in the UK will spray with 2 pack lacquer (polyester) flat and polish has anyone used this method Thanks And...
by andrew bishop
Sat Aug 18, 2012 5:30 pm
Forum: Board Builders
Topic: Hi and 2nd board foam core advice
Replies: 4
Views: 2643

Re: Hi and 2nd board foam core advice

Sorry should of said foam is 1/2" Polyurethane Foam Sheets (12mm) at 2lb @ ft 3 so is very low
but at this stage wont be jumping

Thanks Andrew
by andrew bishop
Sat Aug 18, 2012 3:18 pm
Forum: Board Builders
Topic: Hi and 2nd board foam core advice
Replies: 4
Views: 2643

Hi and 2nd board foam core advice

Hi to all I,m new to the forum and kiteing so please be kind :D Ive just finished my first board 60" x 18" twin tip 1/2 ply core with 2x 4oz for base and 2x12oz for the deck vacuum bagging used to apply .the plan had been to not use any cloth on this one but the ply was so poor I had to http://i1015...

Go to advanced search

cron