You dont have to remove any lines, just make a loop in the line before the connection point and slide it over the existing knot.. If you twisted it the right way it will stay there. You will figure it out by looking at it easily.

No, you basically just put a couple half hitches where the bridle line connects to the kite. Much easier to do than explain

Please not also if you do a mixer test, the b lines should be -3cm. Not sure why they did that, but that is the correct mixer trim

I had the same issues and it took over a year to work out the following fix.. Put an extra larks head in c11 and b13- b17 on each side. Please also let flysurfer know so they dont think I'm crazy lol

I would go to a boating supply store and get some amsteel

It sounds like ion is including a battery and the one on amazon doesnt. Still a pretty large markup consitering how cheaply you can get a battery

If is is a mouth mount, how do you like that? Not sure if I would like it or not.

Very nice! Digging the gopro leash What were you using when hands free? Pacifier mount?

We have the worst luck with forecasted wind in northern michigan. We are not as blessed as many other areas with detailed wind reports and accurate wind modifiers included in the forecast. My skunk rate is pretty high! I could save $100 in fuel pretty quickly if this thing does what it says

I have had bridle issues with my last 2 new naish kites.. Looking at a brand change my self.. One kite came with rear bridles that were over 3" different between them. I suppose its about the same with any brand, the quality control suffers when you farm out manufacturing. I'm sure its super frustra...