*


All times are UTC + 1 hour



Post new topic Reply to topic
 [ 19 posts ]  Go to page 1, 2  Next
Author Message
 Post subject:
PostPosted: Tue Sep 17, 2002 6:55 pm 
Offline
Very Frequent Poster
User avatar

Joined: Sat Apr 13, 2002 1:00 am
Posts: 1810
Location: Vancouver, Canada. rides Naish,Ozone,North, Spotz,Aguera
Here are some popular way to ruin your kite:

Leave it on the beach for hours flapping hard in the wind. This will shred the fabric.

Leave it on the beach in the bright sun. The UV damage will degrade the fabric.

Put it away wet. This will cause the colors to run and cause stains and may also allow mold to grow (especially with fresh water).

Use sharp rocks to hold your kite down on the beach. The pinholes that these may cause can grow into giant rips.

Drag your kite around the beach with the tips scraping ground. It wears them down quickly.

(Most of the wear and tear on most kites occurs on the beach, not in the air.)

Chris G


{ SHARE_ON_FACEBOOK } { SHARE_ON_TWITTER } { SHARE_ON_ORKUT } { SHARE_ON_DIGG } { SHARE_ON_MYSPACE } { SHARE_ON_DELICIOUS }
Top
Profile
 Post subject:
PostPosted: Tue Sep 17, 2002 7:03 pm 
Offline
Frequent Poster

Joined: Mon Sep 02, 2002 1:00 am
Posts: 477
Location: Teahupo'o, Tahiti
lol the above goes without saying but wait you forgot the most important one dude.......

Never let your Girl friend try fly your Kite :smile:

<font size=-1>[ This Message was edited by: Wipirider on 2002-09-17 20:03 ]</font>


Top
Profile
 Post subject:
PostPosted: Tue Sep 17, 2002 7:04 pm 
Offline
Very Frequent Poster
User avatar

Joined: Mon Aug 26, 2002 1:00 am
Posts: 2185
Location: Spain/Italy
Yeah, it's amazing how dragging a kite or anything on the sand will wear it away. It's like sandpapering it.
Jo


Top
Profile
 Post subject:
PostPosted: Wed Sep 18, 2002 11:42 am 
Offline
Very Frequent Poster

Joined: Tue Aug 13, 2002 1:00 am
Posts: 734
I have two perfect ways to trash it:
Nailed a BT 9.4 on a flag pole after a hinderburging.
Landing on total control over a tree. (Late afternoon, long lines!!)


Top
Profile
 Post subject:
PostPosted: Wed Sep 18, 2002 2:19 pm 
Offline
Rare Poster

Joined: Wed Sep 04, 2002 1:00 am
Posts: 23
Location: Austria
Alhtough most kite are dacron leading edge, sun is their worse enemy

:wink:


Top
Profile
 Post subject:
PostPosted: Wed Sep 18, 2002 2:28 pm 
Offline
Very Frequent Poster
User avatar

Joined: Mon Aug 26, 2002 1:00 am
Posts: 2185
Location: Spain/Italy
Something else to watch out for.
I always dry my kites out to prevent rot/mould, even if they're only damp with sand.
With the kite hanging up on the washing line, if the valves of the bladders are open any sand that falls off the kite can fall into the valve if it's pointing upwards and therefore inside the bladder.
Close the valves if you hang your kite up to wash and/or dry.
Jo


Top
Profile
 Post subject:
PostPosted: Wed Sep 18, 2002 3:31 pm 
Offline
Very Frequent Poster
User avatar

Joined: Thu Sep 12, 2002 1:00 am
Posts: 613
Location: Israel
Lighting the leading edge with a match, lighter, or otherwise flamable device is not recommended either...


Top
Profile
 Post subject:
PostPosted: Wed Sep 18, 2002 3:51 pm 
300 hours in direct sunlight is all it takes to end the life of a sail according to Ezzy in his rigging instructions included with each windsurfing sail. I assume that kites would be the same. If no shade is available, I use a UV car cover. You have to be careful with this if it is out of the wind on a hot day - use a pole or something to create some space between the kites and the cover in order to get some air flow. Direct contact will overheat the kites. A quick after work session with low sun angles is no big deal, but an all day session with a couple of kites rigged -- doesn't take long.

Alan


Top
 Post subject:
PostPosted: Wed Sep 18, 2002 3:53 pm 
Offline
Medium Poster

Joined: Sat Aug 17, 2002 1:00 am
Posts: 143
Location: Australia
Jo, I hope your washing line is out of the sun. Otherwise you'll be doing far more damage through UV degradation than mould will ever do.

And if your kite is only wet with saltwater don't even worry about a bit of damp. The saltwater stops mould and in my experience does no damage to kites or sailboard sails too for that matter.

I've never washed my sails or kites, just kept the sand off them by taking them to a grassy area and carefully shaking them out if necessary and then rolling them up. Over the last 15 years the kites and sails I have sold after I've used them have lasted as long or longer than anyone elses. I've also never left them sitting out in the sun or wind if at all possible.

Have fun, Dave (Dr Surf Australia)


Top
Profile
 Post subject:
PostPosted: Wed Sep 18, 2002 3:57 pm 
When buying a used kite, you could find one that is in perfect shape - no repairs - that is completely worn out. Sun fading is a good indicator. Also you can kind of tell by the way the fabric sounds and feels when you wrinkle it up in your hands.

Alan


Top
Display posts from previous:  Sort by  
Post new topic Reply to topic
 [ 19 posts ]  Go to page 1, 2  Next

All times are UTC + 1 hour


Who is online

Users browsing this forum: CaptainB, Google [Bot], Majestic-12 [Bot] and 20 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group