*


All times are UTC + 1 hour



Post new topic Reply to topic
 [ 23 posts ]  Go to page 1, 2, 3  Next
Author Message
 Post subject: gopro camera fogging condensation solutions - mytest results
PostPosted: Fri Jan 25, 2013 2:18 pm 
Offline
Rare Poster

Joined: Thu Jan 24, 2013 3:31 pm
Posts: 4
Hi,

I was sick of my gopro fogging all the time so to find out the best GoPro Hero camera anti fog / anti condensation options I applied the following six different tests:

1. Use GoPro 2 as normal - nothing added

2. Tissue paper inserted down both sides and on back of camera (warning - this could easily jeopardise the water seal if a small amount of tissue is on the seal)

3. Heat camera housing and camera with a hair drier to warm then close housing.

4. Add 3 GoPro dry silica / desiccant strips inside the housing to absorb any moisture in the air and use camera straight away

5. Hold the camera and housing under an air conditioner outlet for 1 minute then close.

6. Insert GoPro 3 dry silica / desiccant strips inside the housing to absorb any moisture in the air and use camera after 17 hours.

These tests were all carried out in Singapore (tropical - 90 miles from Equator c.80% humidity) by submersing the operating Go Pro Hero2 camera in 4 degree Celsius water then removing and trying to film (extreme test).

The anti fog test results are on “Rahotu 200” youtube channel

Other possible anti fog solutions:

a) Store your charged camera in a zip lock plastic bag with silica desiccant pill packets which you get with most electronics. Just before use place in housing while still in plastic bag. This would also assist with keeping your camera away (protecting it) from moisture when not in use.

b) Make sure the inside of the housing and camera is as dry as possible e.g. dry hands, no sweat

c) Don't leave the camera in the direct sun or near heat (put a towel over it or turn your surf board over to keep the camera under the water)

d) Don't leave the camera on (generating heat) when not needed. One button mode I.e. turn off and on at top of camera. – Remember that all the time the camera’s on it’s warming up (built in battery warmer in the Hero2) and all the time it’s off it’s cooling down,

e) Opening the fogged camera housing and wiping off the fog inside then closing seems to lead to less fog next time. Maybe this is to do with the housing/camera being drier.

f) Disable the LED’s – the new GoPro HD Hero has LED’s on the camera body, I’m not sure if this makes a really big difference to the temperature in the housing but it’s easy to disable some, or all of the LED’s. You can tell if it’s recording by listening for the beeps when you turn it on/off or looking at the LCD display.

g) Compact cameras are more susceptible to fogging.

h) Spray on anti fog treatments only allow fog droplets to “flatten” against the lens and are therefore not optically the best solution– removing the humidity is better see Rahotu200 youtube channel.


{ SHARE_ON_FACEBOOK } { SHARE_ON_TWITTER } { SHARE_ON_ORKUT } { SHARE_ON_DIGG } { SHARE_ON_MYSPACE } { SHARE_ON_DELICIOUS }
Top
Profile
 Post subject: Re: gopro camera fogging condensation solutions - mytest res
PostPosted: Fri Jan 25, 2013 6:01 pm 
Offline
Frequent Poster
User avatar

Joined: Sat Feb 16, 2008 6:32 am
Posts: 395
Location: http://www.urbansurf.com/
I've had excellent results using an synthetic shammy cloth as inserts, like that Shamwow product.


Top
Profile
 Post subject: Re: gopro camera fogging condensation solutions - mytest res
PostPosted: Fri Jan 25, 2013 6:27 pm 
Offline
Very Frequent Poster
User avatar

Joined: Wed Aug 24, 2011 11:39 am
Posts: 1068
I just shoot for short burst of a few minutes. Not leaving it on for hours.


Top
Profile
 Post subject: Re: gopro camera fogging condensation solutions - mytest res
PostPosted: Fri Jan 25, 2013 8:47 pm 
Offline
Very Frequent Poster
User avatar

Joined: Mon Feb 11, 2002 1:00 am
Posts: 8305
Location: Florida
I have used a folded paper towel inside the back door of the housing and away from the seals. I've used it above, under the water and in snow in the mountains with good results for the last two years. Sealing the camera in AC helps as well too.


Top
Profile
 Post subject: Re: gopro camera fogging condensation solutions - mytest res
PostPosted: Fri Jan 25, 2013 9:38 pm 
Offline
Very Frequent Poster
User avatar

Joined: Mon Sep 24, 2001 1:00 am
Posts: 29805
Location: World (KF Admin)
what about GoPro 3 ?

I saw, their housing is now flat...does this makes a difference?

Because Contour housing is flat at lens...and it does fog inside, but not in front of lens.


Top
Profile
 Post subject: Re: gopro camera fogging condensation solutions - mytest res
PostPosted: Fri Jan 25, 2013 10:03 pm 
Offline
Very Frequent Poster
User avatar

Joined: Mon Feb 11, 2002 1:00 am
Posts: 8305
Location: Florida
Don't know Toby, I have been using a paper towel in the GoPro 3 housings as well. I don't believe the fogging has anything to do with the shape of the lens port but the differential temperature between the housing interior and exterior. The camera runs hot particularly in video mode.


Top
Profile
 Post subject: Re: gopro camera fogging condensation solutions - mytest res
PostPosted: Fri Jan 25, 2013 11:14 pm 
Offline
Medium Poster

Joined: Thu Apr 22, 2010 10:26 am
Posts: 110
Get a nappy/ diaper and tear it apart to reveal the absorbent inner material. Cut up small bits into rectangles and compress so they are small and thin enough to slide down in between the camera and the housing and back door. You'll yield plenty of useable material from just one nappy and it works a treat! Solved my fogging problems anyway.


Top
Profile
 Post subject: Re: gopro camera fogging condensation solutions - mytest res
PostPosted: Sat Jan 26, 2013 7:20 am 
Offline
Medium Poster

Joined: Mon Feb 06, 2012 4:46 am
Posts: 92
i've successfully used the anti-fog cream for water sunglasses (i think it's $4 us) with great results. also keep a silica gel pack in the housing when i'm not using it. yes, that's a standard silica gel pack that comes in many new products, foods, etc. used to absorb moisture.

good luck.


Top
Profile
 Post subject: Re: gopro camera fogging condensation solutions - mytest res
PostPosted: Sat Jan 26, 2013 5:02 pm 
Offline
Rare Poster

Joined: Sat Jan 26, 2013 1:41 am
Posts: 2
I just leave it in the freezer for atleast 1 hour with the case close but unlock. When I am ready to go, I lock the cover while still in the freezer. Never had condensation since I do that. 8)


Top
Profile
 Post subject: Re: gopro camera fogging condensation solutions - mytest res
PostPosted: Sat Jan 26, 2013 9:29 pm 
Offline
Very Frequent Poster
User avatar

Joined: Thu Jun 05, 2008 1:52 am
Posts: 1187
Location: Thailand
Snowkiter1963 wrote:
I just leave it in the freezer for atleast 1 hour with the case close but unlock. When I am ready to go, I lock the cover while still in the freezer. Never had condensation since I do that. 8)

10 minutes or less will do, even in a fridge. The air in the case will quickly be as dry as the air in the fridge. :thumb:


Top
Profile
Display posts from previous:  Sort by  
Post new topic Reply to topic
 [ 23 posts ]  Go to page 1, 2, 3  Next

All times are UTC + 1 hour


Who is online

Users browsing this forum: Baidu [Spider], Lazy kiter, windrupted and 18 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group