I have a 2008 Cabrinha Convert in 2:1 configuration. I'm trying to change it from 2:1 to 1:1 to decrease the pull on the bar.
I think I have set it up in 1:1 bridal mode but the pulley bit doesn't look right. The loop doesn't close around the pulley. Is this how it should be?
If there is any Cabrinha expert out there then please confirm if I have the correct setup.
I have taken 2 images of the pulley.
I've been told that the "Braid" should be pulled through the pulley but the issue is that the Braid has very thick ends and doesn't go through the pulley. I may be able to do it with some force but don't want to break the pulley.