Joined: Sat Apr 30, 2011 11:26 pm Posts: 120 Location: Europe
If you look at the glass plate in the video, you notice that it looks frosted on the parts where the liquid does not stick. That is because the everdry, or similar product neverwet, create this type of coating. So, putting this on your gopro lens might repel water, but on the contrary your films will be forever foggy looking...
Put it on the bottom of the board instead to go faster! Or on the lines. Or on the wet (then dry) suit!
This stuff looks INCREDIBLE. I wonder if it would keep swimming goggles, dive masks, gas masks etc. from fogging up ?
Or how about a specialty makeup for hookers and porn actresses ?
Again, however incredible this product is, it leaves a frosty surface on anything it is applied to, so any clear material (glass etc) will become frosted. Sure, no fog, but on the other hand no visibility.
If you look at the video, anything it is applied to is slightly grey, frosted. Bolts, shoes, glass, stone...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum