Contact   Imprint   Advertising   Guidelines

Removing the swivel from a 2013 ATB Naish bar

forum for kitesurfers

User avatar
Very Frequent Poster
Posts: 2632
Joined: Mon Mar 16, 2009 4:35 pm
Kiting since: 2009
Local Beach: Kp, MBay, Rond
Favorite Beaches: Kp, MBay, Rond, Long Bay, Cayo Guillermo
Gear: Ocean Rodeo Gen4 Flites 10m, 12m and 14.5m, 2016 Prodigy 5m and 7m
Xeon Laluz, 2010 OR Mako Wide 150, Mako Classic 150, Jellyfish Custom surf board quad fin 6'
Engine Custom Harness and sliding hook setup
Location: Southwestern Ontario

Re: Removing the swivel from a 2013 ATB Naish bar

Postby Laughingman » Tue Jan 21, 2014 3:36 am

Edt thanks for your help. I've decided to test how much wear the ring/ball causes on the line. So here is the finished product. I'll spend some time going forward designing something that works like yours but may swivel....
The red pig tail with the two rings goes through the webbing loop and is sewn to the webing and the webing is sewn tight closing any opportunity of one side getting off side.

Single centre line flag. Stopper ball. Below the bar swivel. Debatable adjustable width. Shortened pull/pull to clean up a bit of mess. 1st. Test in Cuba in a few weeks.

Return to “Kitesurfing”

Who is online

Users browsing this forum: Bartolo, Bing [Bot], Frank82, Google [Bot], Kau pi kite tarifa, riddim1, tonyh and 31 guests