*


All times are UTC + 1 hour



Post new topic Reply to topic
 [ 11 posts ]  Go to page Previous  1, 2
Author Message
 Post subject: Re: Removing the swivel from a 2013 ATB Naish bar
PostPosted: Tue Jan 21, 2014 3:36 am 
Offline
Very Frequent Poster
User avatar

Joined: Mon Mar 16, 2009 4:35 pm
Posts: 1549
Location: Southwestern Ontario
Edt thanks for your help. I've decided to test how much wear the ring/ball causes on the line. So here is the finished product. I'll spend some time going forward designing something that works like yours but may swivel....
The red pig tail with the two rings goes through the webbing loop and is sewn to the webing and the webing is sewn tight closing any opportunity of one side getting off side.

Single centre line flag. Stopper ball. Below the bar swivel. Debatable adjustable width. Shortened pull/pull to clean up a bit of mess. 1st. Test in Cuba in a few weeks.


Attachments:
image.jpg
image.jpg [ 1.75 MIB | Viewed 182 times ]
image.jpg
image.jpg [ 1.98 MIB | Viewed 182 times ]
Top
Profile
Display posts from previous:  Sort by  
Post new topic Reply to topic
 [ 11 posts ]  Go to page Previous  1, 2

All times are UTC + 1 hour


Who is online

Users browsing this forum: Bing [Bot] and 17 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group