I bought a New North SELECT board 2014, after 10 session in Brasil i Noticed that the board is worn out under the pads.... (See pictures)
Does anyone had similar Problem?
I sent an e mail to North and the reply was:"our warranty does not cover worn out boards
" and "the Problem was not the board but the Sand of Brasil...".
( 10 sessions!!!!!)
Just start to look after your board if you don`t want to see such marks.
Scratches are harmless to your board and they always appear to any glossy finished one.
wash my gear afterwards and since I make my own boards noticed this is caused by NTT pads.
It is clearly visible on the photo above. North added some foam under the NTT for 2013, but now is late...It's a design issue.
They should address this looong before 2013 NTT's. How many old pre 2013 NTT's are out there?
Same thing down to the FG.
As suggested, put some foam under the pads or rubber as I did:http://boardbuilders-forum.1077691.n5.nabble.com/file/n1266/DSC00538_%28Small%29.jpg
Just today I deleted my post here asking what kind of foam North is using so I can equip my pads as well (got 5 new pairs). Unfortunately no one replied, so deleted it.