how to best repair a repaired valve

[knyfe]

My repair sticker with the valve just came off the tube again. Whats the best way to fix it? What solvent should I use to best wipe off the old glue off the tube. Just clean as much as possible and try another sticker to get another 2-3 years out of it?

Just resticking it did not work I already tried that /-)

THNX G

[edt]

rubbing alcohol is usually the best. You don't have to get it all off just get all the loose stuff off, then sand the surface. Sanding the surface before doing a restick ensures you have a mechanical adhesion in addition to the chemical one.

[knyfe]

THNX. Restick the same sticker or a new one? G

[JakeFarley]

If it is the original valve, glue it back on with 3m 5200 fast cure, Stormsure, or Aquaseal. Clean it real good as previosly stated. I used valve donuts and got a bad batch, lasted only 6 months, so I glued all the valves on my HP Nemisis.

[edt]

dont use valve donut use a whole new stick on valve or use glue like described by jake farley. valve donuts last 1 year maybe 2 then they decay. When they first came out I thought they were good but they don't last long.

[Herman]

Even with a new stick on I put a bead of aquaseal around the edge ~ 2mm overlap each side of edge. Never had a replacement come off yet, but there's still time!