Contact   Imprint   Advertising   Guidelines

Nobile TT Fin Conversion

forum for kitesurfers


User avatar
ShaveTheWhales
Frequent Poster
Posts: 494
Joined: Sun Oct 27, 2013 1:28 pm
Kiting since: 2008
Gear: Naish, Epic, F-one, Shinn
Brand Affiliation: Anything that jumps well and fun to fly

Nobile TT Fin Conversion

Postby ShaveTheWhales » Wed Mar 14, 2018 10:01 pm

A little mod tip for Nobile riders... who have their crap plastic bits break or loose fins that vibrate..

"Nobile"... Polycarbonate would have been reliable long term.

I have the 2HD that had the stupid plastic single screw setup, ended up converting to normal fins.

1. Remove the plastic fin plate attached to board.
2. Fill the holes with resin or 5 min araldite..
3. Drill new holes where the 2 tiny screws were. Rule a line through the centre's to get it straight..
4. Make sure you use a load spreading spacer/washer screw plate - when attaching fins..
(The old elongated hole will reduce strength in fin area)
5. Fit your favourite fins and Rock on - like Normal kiteboarders :thumb:

Return to “Kitesurfing”

Who is online

Users browsing this forum: Goavegas, rogue_kiteboarder, SaltWaterDog, spatty99, The Captain and 28 guests