Page 1 of 1

Posted: Sun Apr 21, 2002 4:09 pm
by Sake
I bought a new harnass last year june and have used it a lot. A
Wipika seat harnass. Now I allready see wear at de bands that hold
the spreader bar.

On one side it's allready quit a cut-out. On the side where I open
the band to get out of my harnass it's less than on the other side of the spreader bar.

So wil a harnass last shorter when using it for kitesurfing than using it for windsurfing? In the time I windsurfed, the harnass lasted for years. At least 4 or more years.

Is there any way to repair/replace the bands?
Is there any way to avoid the wear? DaKine "Pivot bar" ?
Is someone using a harnass for over a year that does not show any(or little) wear at the bands that hold the spreaderbar?
????????????

I ask this question, because a friend had the bad situation that the band actually ripped apart. Resulting the bar hitting him in the face and causing an injury! I don't want that to happen if I can avoid/prevent it!

Posted: Sun Apr 21, 2002 8:38 pm
by Sake
In another forum I was advised to just replace the "bands"

Good idea?

Posted: Sun Apr 21, 2002 8:58 pm
by Toby
it is no problem to replace the baands.
It did it too since it is very dangerous to ride with an almost ripped up band.
Your friend is th best example. Avoid it by changing the band more often. Shouldn't be more then 10-15 Euros. The harness still be fine, but the band always suffers under the pressure of the kite.

Posted: Sun Apr 21, 2002 9:36 pm
by Sake
Thx!
If I would not have asked the question here and in other forums, I would have bought a new harnass.

Save's me some Euro's and still be safe!

Posted: Mon Apr 22, 2002 7:00 am
by BlueSky
Go to a shoerepairstore. They can stitch very well. Did the same with my old windsurf seat harness (after tying the leash to the wrong part of the seat harness.....)

Posted: Mon Apr 22, 2002 7:20 am
by Toby
that is a good idea, too.
But you also can go to sail repair shops, they do it within 10 min. Whatever is closer to oyu. But I don't know if the shoe repair has the band you need?

Posted: Mon Apr 22, 2002 3:20 pm
by Royce
Tie a granny knot right at the wear spot in both sides of the webbing if you have enough space. Then center the bar and you will be able to use it for ages longer without the repair. And those annoying webbing flaps won't get in the way. Also for a great harness try the Prolimit Felix Peviel model. Don't know how long it will last but it sure is a great feeling harness.