Contact   Imprint   Advertising   Guidelines

How Thin Can I Go?

here you can exchange your experience and datas about your home build boards


off da lip
Rare Poster
Posts: 7
Joined: Tue Nov 23, 2004 7:42 pm

ITCHY-SCRATCHY SHOW

Postby off da lip » Thu Nov 25, 2004 4:28 pm

I was on my short board yesterday and was stoked on how well the 1/8 inch rails dug in and went to windward ,These rails are covered in a 20 oz tri-ax and 6 oz cloth (twice) ,very hard to wrap, but the board is very tough,bends a lot and doesn't break

Guest

Postby Guest » Fri Nov 26, 2004 10:07 am

Hi,

I just have build a real thin board, made with a 2,5mm plywood core und 10mm concave in 138 x 38. After covering with 3 X 65 g/m2 carbon-Kevlar on deck and bottum and some Carbone in the middle it was really soft . After Stiffing it with 8 cm thin strip in 10 layer Carbon UD and cloth on the heelside and some extra layers in the middle it is really fine. Good grap and nice Pop. Weight is normal.
:bye:

Lars

Mitchel_12000

Postby Mitchel_12000 » Sun Feb 06, 2005 12:43 pm

So if I understand right, you have more concave in the tips then you have in the middle. What's the benefit of this?

crabman
Medium Poster
Posts: 158
Joined: Mon Dec 05, 2005 4:44 pm

Postby crabman » Wed Dec 28, 2005 1:54 pm

8mm is the thinest we have gone with 2mm tips


Return to “Board Builders”

Who is online

Users browsing this forum: No registered users and 4 guests