Hello

Can someone give me advice on how to secure the footstraps and grab handle to a corecell kiteboard. I have produced 2 boards, 137cm x 37cm x 12mm (3 x 4mm foam) and 110cm x 40xm x 8mm (2 x 4mm foam). Intend to laminate with carbon/glass using epoxy.

Are you using purpose built inserts (if so, where can you buy them in the UK) or just screwing the footstrap/handle into the deck? Any advice welcome.

Thanks

Martyn

You are adding insert plugs on your board right?, just do the same for your grab handles .t nuts windsurfing plugs etc.....good luck DAVE

i think you can use T nuts...
http://www.stafast.com/utnut.html