*


All times are UTC + 1 hour



Post new topic Reply to topic
 [ 1 post ] 
Author Message
 Post subject: Screws rule for making kiteboards
PostPosted: Sun Jul 24, 2005 3:48 am 
Offline
Very Frequent Poster
User avatar

Joined: Tue Dec 23, 2003 6:30 pm
Posts: 845
Location: Traverse City, MI usa
I thought I post this for the Newbe board builders. One of the most easy way of laminating is using Drywall screws, whether a flat board or concave, rocker etc. Take a 3/4 in ply or chip board for the base and just screw the thin ply together to that board, just make sure you have wax paper under your thin ply. Rocker and fip tips just put a piece of wood at the ends of the board and screw down your ply. Concave slighty more conplex take a strip of wood down the center then put some thin ply on top for a jig table, then screw your ply down.

Screw holes are filled with Epoxy and wood dust/flour/microballons/etc
If your good you dont even see these holes once filled

Easy


{ SHARE_ON_FACEBOOK } { SHARE_ON_TWITTER } { SHARE_ON_ORKUT } { SHARE_ON_DIGG } { SHARE_ON_MYSPACE } { SHARE_ON_DELICIOUS }
Top
Profile
Display posts from previous:  Sort by  
Post new topic Reply to topic
 [ 1 post ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group