Contact   Imprint   Advertising   Guidelines

Holes and sealing ply around T Nuts - Poly enough?

here you can exchange your experience and datas about your home build boards


adamdw
Rare Poster
Posts: 8
Joined: Tue Sep 12, 2006 6:59 pm

Holes and sealing ply around T Nuts - Poly enough?

Postby adamdw » Wed Nov 01, 2006 11:11 pm

Hi - Quick Question

About to drill the holes through a ply board for putting in T nuts and my question is....

Can I get away with sealing with poly - from the advice on the forum I plan to do a spit coat half thinner/half poly then 6 or so coats of poly but is poly enough to stop the water getting in and delamming the board where the holes/T Nuts are????? I don't have the patience or access to materials here for epoxy.

Cheers, Adam

Return to “Board Builders”

Who is online

Users browsing this forum: No registered users and 2 guests