Joined: Sat Dec 27, 2003 11:59 pm Posts: 301 Location: Leeuwarden, Netherlands.
I recently finished another board. It's my 13th creation.
It's a 120 X 36 board. Sidewalls are 4 mm. I shaped the corecell from 6.6 mm in the middle to 0 at the edges. To create more flex in the tips, the corecell stops 8 cm before the tips, so the tips are only 2 layers of plywood.
Durasurf topsheet (glossy)
Plywood 1,5 mm
corecell 6.6 mm
plywood 1,5 mm
durasurf topsheet (glossy)
No glassfibre cloth used. I just used epoxy with filler (chopped glassfibre) to bond the layers together.
Flex is really awesome again. The finish of the board is average. Some airbubbles were captured underneeth the topsheet. It was the first time I used vacuum technique, so afterall I'm pretty satisfied with the result and I've learned alot to improve. I hope I can test it tomorrow! Still have to assemble my yellow ConceptX fins.
Proto-120-X-36.jpg [ 69.93 KIB | Viewed 1582 times ]
Nice . To get rid of bubbles on the base ,lay it up flat ,flow coat, and finish it before applying vacuum for the finished board .Finish the core off just past the inserts to get max flex tips . Nice board by the way . Self builds rock.
Users browsing this forum: No registered users and 3 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum