Contact   Imprint   Advertising   Guidelines

MTB re-painting

here you can exchange your experience and datas about your home build boards

Rare Poster
Posts: 1
Joined: Tue Aug 08, 2006 5:33 pm
Kiting since: 0
Brand Affiliation: None
Location: Rome -Italy

MTB re-painting

Postby ready2fly » Wed Nov 08, 2006 9:33 am

Hi guys,

I had to repaint my Scrub Quasar because it was getting really scratched.
I have removed the original painting and I found I like the wood like aspect it has now.
Here is the question: which is the best way to paint it in trasparent mode: epoxy resin or transparent painting or what else?

I would like to be sure that wood is proctected against humidity and that the painting will not break because of the board flexibility.

Any idea, suggestion?

Here there is a pic of the work-in-progress: ... t&id=10277


Frequent Poster
Posts: 284
Joined: Mon Mar 27, 2006 12:57 am
Kiting since: 0
Brand Affiliation: None
Location: Maui,Hawaii

Postby Halomon » Sun Nov 12, 2006 9:31 pm

Hello Andrea; My advice about your resurfacing job is to go with fast drying, two part epoxy resin. If applied correctly it should leave a thick, flexible, clear and glossy skin on your board that will proctect it well. Ask around your local surfboard shops where you can pick some up. There are different types of epoxy; get the fast drying type used for surfboards; apply it correctly and you will be set. You can apply multiple coats by lightly sanding in between coats. Take care and ride safe!! Chow

Return to “Board Builders”

Who is online

Users browsing this forum: No registered users and 1 guest