*


All times are UTC + 1 hour



Post new topic Reply to topic
 [ 3 posts ] 
Author Message
 Post subject: Board Design - comments please
PostPosted: Mon Dec 11, 2006 2:33 pm 
Offline
Medium Poster
User avatar

Joined: Fri Dec 09, 2005 11:45 am
Posts: 132
Ok After months of trawling through various forums and websites I think I'm slowly (but still uncertain) understanding what goes into making a board - I may be completely wrong. However finding all the little details is pretty tough hence this post.

Anyhow I've put together my ideas and i'd be grateful for your comments. Its a lightish wind board with hopefully a little bit of speed too.

I also hope to post a similar thing on the whole process, including my rocker table, construction sequence etc.

Very grateful of any constructive comments

[/img]


Attachments:
Noo Noos board plans.pdf [20.43 KIB]
Downloaded 495 times
{ SHARE_ON_FACEBOOK } { SHARE_ON_TWITTER } { SHARE_ON_ORKUT } { SHARE_ON_DIGG } { SHARE_ON_MYSPACE } { SHARE_ON_DELICIOUS }
Top
Profile
 Post subject:
PostPosted: Tue Dec 12, 2006 7:47 am 
Offline
Frequent Poster

Joined: Thu Jul 14, 2005 10:00 pm
Posts: 290
Location: Sydney Australia
Noo - looks like you've done more planning than plenty of other builders! My comments on your design are the following:

I think you could increase your concave a few mm. 4mm over a 43cm wide board seems pretty low.

Your outline is a little segmented. I think I'd round the smaller corners part way along the rails. This should give you more consistent carving on the rail.

Your inserts look similar to the ones I use. Be sure to put plenty of glass over these as they take a fair pulling load when dragging the the board through the water with your feet still in the straps.

They are pretty minor comments though. The good thing about kiteboard design is that almost anything works! Let us know how you get on through construction.


Top
Profile
 Post subject:
PostPosted: Tue Dec 12, 2006 9:04 am 
Offline
Medium Poster
User avatar

Joined: Fri Dec 09, 2005 11:45 am
Posts: 132
thanks Munteruk. yes I want to get as much planning done as possible now. I can't afford / I want to give myself the best chance of getting the first one right.

Comments gratefully received - I'll look at the concave and the overall outline. The enclosed drawing was done without any scale etc.

As I build up the specifics I'll add these to this post.

Difficult part next though as I've been trying to fathom out the finer detials of vacuum bagging etc. Part 2 to follow soon I hope.

thanks again.


Top
Profile
Display posts from previous:  Sort by  
Post new topic Reply to topic
 [ 3 posts ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group