vac bagging/ rocker table
-
rocketpants
- Rare Poster
- Posts: 2
- Joined: Sat Jan 27, 2007 9:19 pm
- Has thanked: 0
- Been thanked: 0
vac bagging/ rocker table
just curious for kiteboard building info... what density of divinycell is best? what weights of fibre/carbon fibre cloths are best for the glassing stages? is there an inexpensive way of making an effective vac/rocker table? can I find plans for such a thing? any info muchly appreciated...
-
TomW
- Very Frequent Poster
- Posts: 3585
- Joined: Wed Oct 05, 2005 6:43 pm
- Kiting since: 2001
- Local Beach: Vejbystrand, Lomma
- Gear: TW Surfboards hydrofoil board 110
Gong Veloce M, 100cm carbon mast
Ozone Hyperlink V1 7m
Hyperlink V2 9m, 13m
Concept Air Wave 4,5m - Brand Affiliation: None
- Location: Sweden
- Has thanked: 53 times
- Been thanked: 193 times
Divinycell H80
I use 245g/m2 carbon and 3 layers 165g/m2 glass each side.
Layup:
glass
glass
Carbon
Glass
Core
Glass
Carbon
Glass
Glass
Rocker table:
simple no concave rocker- use a sheet of Polycarbonate plastic 5mm and screw in down to wood stringers with the right rocker cut into them. I actually screww the stringers to a table and use spacers under th stringers to make the rocker.
Others?
I use 245g/m2 carbon and 3 layers 165g/m2 glass each side.
Layup:
glass
glass
Carbon
Glass
Core
Glass
Carbon
Glass
Glass
Rocker table:
simple no concave rocker- use a sheet of Polycarbonate plastic 5mm and screw in down to wood stringers with the right rocker cut into them. I actually screww the stringers to a table and use spacers under th stringers to make the rocker.
Others?
- Attachments
-
- 18mm concave over 34cm width. Table is 60cm wide, 4mm MDF with glass expoxy layer.
- rockertable.jpg (21.9 KiB) Viewed 2759 times
Who is online
Users browsing this forum: No registered users and 214 guests