Contact   Imprint   Advertising   Guidelines

New board, old board

here you can exchange your experience and datas about your home build boards

Very Frequent Poster
Posts: 3285
Joined: Thu Jun 05, 2003 3:37 am

New board, old board

Postby BWD » Sun May 20, 2007 3:46 pm

Latest board
4mm concave
birch ply epoxy composite
machined ply/foam core
~3.8g - the ply sheets used were denser than usual :-? likely won't break at least.
Built on "commission" for my friend Stew who liked it's quasi-identical twin predecessor.
Ironically I lost the original proto, my main light wind ride, just before completing this one. Too bad no A-B comparison.

Maybe will build and post version 3 later...
meet the new boss, same as the old boss.JPG
Core on the left is now inside board on the right....
meet the new boss, same as the old boss.JPG (73.39 KiB) Viewed 1323 times

Return to “Board Builders”

Who is online

Users browsing this forum: No registered users and 1 guest