First board started
Posted: Wed Apr 04, 2007 9:23 am
Last night we started to make my first kiteboard, I am using 1/2" birch plywood, and intend to keep the board flat.
Let me know what you think, I thought it looked fine last night, but looking at the pictures it seems a bit fat in the middle.
It is 146cmx46cm, and the ends taper in to about 29cm.
Should I trim a bit off the sides to make it less of a curve, or might it be ok? If it's not going to work, I can start again, there's still lots of my 8x4 left!
Thx
S.
PS excuse the slightly non-symetrical ends, they are still in progress!!
Let me know what you think, I thought it looked fine last night, but looking at the pictures it seems a bit fat in the middle.
It is 146cmx46cm, and the ends taper in to about 29cm.
Should I trim a bit off the sides to make it less of a curve, or might it be ok? If it's not going to work, I can start again, there's still lots of my 8x4 left!
Thx
S.
PS excuse the slightly non-symetrical ends, they are still in progress!!