Here you can exchange your experience and datas about your home build boards
-
BWD
- Very Frequent Poster
- Posts: 3849
- Joined: Thu Jun 05, 2003 3:37 am
-
Has thanked:
2 times
-
Been thanked:
81 times
Postby BWD » Sun May 20, 2007 3:46 pm
Latest board
145x42
4mm concave
birch ply epoxy composite
machined ply/foam core
~3.8g - the ply sheets used were denser than usual
likely won't break at least.
Built on "commission" for my friend Stew who liked it's quasi-identical twin predecessor.
Ironically I lost the original proto, my main light wind ride, just before completing this one. Too bad no A-B comparison.
Maybe will build and post version 3 later...
-
Attachments
-
- Core on the left is now inside board on the right....
- meet the new boss, same as the old boss.JPG (73.39 KiB) Viewed 1567 times
Return to “Gear Builders”
Who is online
Users browsing this forum: No registered users and 77 guests
