Joined: Mon Jan 16, 2006 12:44 am Posts: 69 Location: US
This one is Just a Divincell H80 3/8" Foam Core. I have done wood cores and Hybrid wood/foam and they are all made the same. Cast epoxy and Micorpheres for the rails. Graphix... vehicle wrap. I also have the same place print graphix on cotton for layup under my fiberglass but this one is just wrapped and then clearcoated.
How did you do the rails? I'm building a board right now and I'm not totally sure on the rails. I'm building a carbon board and want to make a poured epoxy rail for it, like you did. When I cut out the woodcore I'll save the "left over wood" and use it as a mould. I'll then cut of 0,5mm of the board and then fill the gab with epoxy. So I think, I got that covered. But afterwards what then? Can I just cut of the rest of the carbon and sand it down to make a smooth rail?
Users browsing this forum: No registered users and 4 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum