Slowly getting my first board done
Posted: Mon Jun 20, 2011 6:16 am
Hey everyone
I have been working on my first board. It's 160 x 48, 3 layers of 1/8 inch Okoume marine plywood, and I don't have a precise scale to weight it on but feels like it weighs as much if not more than my Spleene rip 134 already. I was originally planning on doing 3 layers of 3.6 oz e glass top and bottom. I am wondering if I might be able to do 2 layers instead to save some weight. I tried to put about 3 cm of rocker in it when I glued the layers together but i clamped the middle down to hard so all the rocker is in the tips. The top piece is off center towards the heel side a bit and to pads, I got a sert of liquid force comps for a decent price, are slightly offset as well.
Let me know what you think.
I have been working on my first board. It's 160 x 48, 3 layers of 1/8 inch Okoume marine plywood, and I don't have a precise scale to weight it on but feels like it weighs as much if not more than my Spleene rip 134 already. I was originally planning on doing 3 layers of 3.6 oz e glass top and bottom. I am wondering if I might be able to do 2 layers instead to save some weight. I tried to put about 3 cm of rocker in it when I glued the layers together but i clamped the middle down to hard so all the rocker is in the tips. The top piece is off center towards the heel side a bit and to pads, I got a sert of liquid force comps for a decent price, are slightly offset as well.
Let me know what you think.