Daydan if you are short just grab some paper towel and triple layer it. will do the same thing if you put it ontop of the peel ply. sucks up all the extra resin.
Johnny. infusion is the way to go now a days.. less resin, better finish, and just plain cool to watch is cross over. It does cost alittle more to do with the wicking material but in the end I think you save in epoxy.
do your pull, open your resin line, watch it cross until about 3/4 or alittle more the way and close the resin line , you should have enough to get to the end. low voc resin. RR works great.
I tip. the bigger the part the slower the hardner. the heat gets too hot and starts to set before it crosses over to the other end other wise.
just trying to help
"chasing my dream one letter at a time"