Here you can exchange your experience and datas about your home build boards
-
zob
- Frequent Poster
- Posts: 476
- Joined: Tue Feb 24, 2009 1:43 pm
- Local Beach: Grado Pineta (IT), Fossalon (IT)
- Style: Freeride, strapless hooked-in
- Gear: FS S3 19m2 DLX, S3 CE 12m2 DLX & S4 8m2 DLX
Homemade Surf & Snow Boards
MBS Pro90
- Location: Iv.G.-Slovenia
-
Has thanked:
21 times
-
Been thanked:
3 times
-
Contact:
Postby zob » Tue Aug 14, 2018 4:14 pm
Getting rid of Air bubbles on the bottom is the toughest for me in building process. And they only get bigger in the heat of the sun.
Doing it with a Isosport sheet will only result in way way worse result.
-
phuqit
- Rare Poster
- Posts: 36
- Joined: Thu Jun 21, 2018 2:03 pm
- Local Beach: Kaunas
- Gear: Flusurfer Soul 12, 21m
Flysplit 2 board
- Brand Affiliation: None
-
Has thanked:
0
-
Been thanked:
0
Postby phuqit » Tue Aug 14, 2018 5:03 pm
re bubbles: I'm more or less convinced, that the dry spots were caused by me leaving the pump on for long time after injection - it simply sucked out some more resin than was required.
re soric: this actually looks like a good idea. I might buy some and try it out.
-
phuqit
- Rare Poster
- Posts: 36
- Joined: Thu Jun 21, 2018 2:03 pm
- Local Beach: Kaunas
- Gear: Flusurfer Soul 12, 21m
Flysplit 2 board
- Brand Affiliation: None
-
Has thanked:
0
-
Been thanked:
0
Postby phuqit » Tue Aug 14, 2018 9:43 pm
Warren @ easycomposites says the following regarding dry spots on the bottom:
>Yes I suspect you are right that leaving the pump running caused the dry spots. Even with a resin break it can still dry out. When we infuse, we always ensure we have a leak tight bag as after the infusion, we turn off the pump. We clamp the vacuum line, allow the resin feed to stay open another 20 seconds or so, then clamp the resin feed as well. However it only works if you have a good bag hence why we recommend carrying out a proper leak test before you begin.
-
rynhardt
- Very Frequent Poster
- Posts: 980
- Joined: Wed Sep 11, 2013 3:51 pm
- Local Beach: Langebaan
- Favorite Beaches: Langebaan
- Style: Freeride
- Gear: Cloud C2 17
Hoff Twinwave
- Brand Affiliation: None
- Location: Johannesburg, South Africa
-
Has thanked:
25 times
-
Been thanked:
30 times
Postby rynhardt » Wed Aug 15, 2018 10:13 am
zob wrote: ↑Tue Aug 14, 2018 4:14 pm
Getting rid of Air bubbles on the bottom is the toughest for me in building process. And they only get bigger in the heat of the sun.
Doing it with a Isosport sheet will only result in way way worse result.
Depends on your prep work. If you have enough channels and holes you can get rid of the dry spots very effectively.
I've had excellent results with Isosport 6000.
Return to “Gear Builders”
Who is online
Users browsing this forum: No registered users and 75 guests