Whenever I backloop or frontloop, the safety line (fifth) places itself laterally to (instead of between) the front lines inside the hole in the bar. This makes the bar movement difficult and I assume it causes wear to the lines and safety release may not work properly. I can reposition it by pulling it medially (towards the center, between the front lines) but it is difficult and I risk my fingers a bit. Anyone else with the same problem? Any ideas from the Flysurfer team? Also, there is rust after only 15 times in the water on a couple of metal bits of the safety release mechanism. Any ideas? Should it not be rust-resistant?
Users browsing this forum: No registered users and 3 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum