( Course Racing Equipment (a submission from PKA)
To limit the maximum amount of fins to 4 and require them to be production. Maximum 1 set of fins to be used during one event. Minimum production number of fin sets: 50
The motion around the table was that free choice of fins are essential to trim the boards for different wind and water conditions especially taking into account that only 1 board may be registered per event.)
We are a lot of beginners in kiterace.
Can you explain how choice of fins for different wind and water conditions?
oliver vlc wrote:( Course Racing Equipment (a submission from PKA)
To limit the maximum amount of fins to 4 and require them to be production. Maximum 1 set of fins to be used during one event. Minimum production number of fin sets: 50
The motion around the table was that free choice of fins are essential to trim the boards for different wind and water conditions especially taking into account that only 1 board may be registered per event.)
We are a lot of beginners in kiterace.
Can you explain how choice of fins for different wind and water conditions?
Thanks.
big fins will drive up wind better and be definitely a better light wind alternative...shorter fins are easier to control and goes down wind (apparently) better....but dosn't have the same drive...then there is a ton of different angles...etc.