*


All times are UTC + 1 hour



Post new topic Reply to topic
 [ 33 posts ]  Go to page Previous  1, 2, 3, 4
Author Message
 Post subject: Re: Why the long depower rope??
PostPosted: Wed Aug 10, 2011 3:34 pm 
Offline
Frequent Poster

Joined: Sun Oct 26, 2008 5:29 pm
Posts: 484
I totaly flamed out and right inside of west marine I started rigging. I didnt really look at the orbit blocks card. I ripped the thing right off, and tried to work with it. I did not see any white rope. I went right over to the shelf and ripped a harkin block out. That seemed better to me, only cause the orbit pulley was missing pieces. I paid for everything of course. I didnt want to drive back.

What do you thing I should use? It was not a cheap pulley.


Top
Profile
 Post subject: Re: Why the long depower rope??
PostPosted: Wed Aug 10, 2011 10:53 pm 
Offline
Very Frequent Poster

Joined: Sun Jul 24, 2005 6:39 pm
Posts: 3006
AndrewJMcGee wrote:
I totaly flamed out and right inside of west marine I started rigging. I didnt really look at the orbit blocks card. I ripped the thing right off, and tried to work with it. I did not see any white rope. I went right over to the shelf and ripped a harkin block out. That seemed better to me, only cause the orbit pulley was missing pieces. I paid for everything of course. I didnt want to drive back.

What do you thing I should use? It was not a cheap pulley.


The pulley has to be rigged through the hole that the wheel rotates round for it to achieve its maximum working load. If you google orbit pulley, you can see several examples including the way ronstan recommend.
Here is one way to do it.
http://www.extremekites.com.au/content/ ... pulley.jpg

This photo shows the rope Ronstan supplied with my series 20 pulleys, You just loop it through the centre of the wheel 2 or 3 times like this to create a loop.


Attachments:
RF25109%20with%20rope.jpg
RF25109%20with%20rope.jpg [ 834.13 KIB | Viewed 424 times ]
Top
Profile
 Post subject: Re: Why the long depower rope??
PostPosted: Thu Aug 18, 2011 5:51 am 
Offline
Rare Poster

Joined: Fri Jun 11, 2010 3:29 am
Posts: 7
As far as blocks go, I've always used Harken blocks on racing sailboats and now kite bars.

Easy to clean out sand and mud from the block bearings with a quick dunk and spin of the sheave.


Top
Profile
Display posts from previous:  Sort by  
Post new topic Reply to topic
 [ 33 posts ]  Go to page Previous  1, 2, 3, 4

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group