I am looking for some advice on how to know if the inside of the leading edge is clear of anything that could cause pin prick holes.
Backgrond ... I landed the kite on some prickly grass at a new location.... leading edge had 6 pin prick holes in it that patched with Tear Aid and bladder. The bladder after repairing was holding air overnight. Struts as well.
When i reinserted (carefully) the LE and connected all the one pumps there is still a slow leak just in the LE. I am speculating that there is a thorn or something as i know that it is not the strut connections for the one pump.
Any advice on how to know that the LE inside of the kite is clear of any pricks or thorns ?
I am concerned that just removing and repairing a new hole will lead to the same outcome of slow leak in LE.
thanks in advance