Contact   Imprint   Advertising   Guidelines

Use vacuum storage bags for vac bagging

Forum for hydrofoil builders.

Frequent Poster
Posts: 264
Joined: Sun Jan 09, 2011 6:03 pm
Kiting since: 0
Brand Affiliation: None

Use vacuum storage bags for vac bagging

Postby faklord » Thu Oct 13, 2016 8:43 pm

Posted this up on the Board Builders forum but its probably even more relevant to smaller hydrofoil parts:

....... I have had good success using Vac storage bags for vac bagging.
The largest I have found are 180 x 110cm ( ... Q2RSPVITY6)
That's big enough for a smallish surf board or massive TT....but there are loads of different smaller sizes
Had to make a little adapter for my vac setup but that was easy enough. I turned one out of nylon but a correctly sized rubber bung should do it.

1) Re usable. Saves on all that tack tape etc.
2) Reliable seal every time...wooo hooo!
3) Easy to quickly open and correct something inside if something isn't quite right.
4) Can use vac cleaner to quickly pull out volume, then switch to vac pump to pull down to low pressure.

Rare Poster
Posts: 27
Joined: Sat Mar 18, 2017 10:09 am
Kiting since: 2015
Local Beach: Squamish, BC
Gear: North kite
Brand Affiliation: None

Re: Use vacuum storage bags for vac bagging

Postby Lev737 » Thu Mar 30, 2017 9:32 am

The best vacuum bagging material is here:
and bag seals
Regards :jump:

Return to “Hydrofoil Builders”

Who is online

Users browsing this forum: No registered users and 3 guests