forum for snow- and landkiters
- Rare Poster
- Posts: 19
- Joined: Mon Sep 16, 2002 1:00 am
Someone mentioned this a while back and I was interested in modifying my mountainboard the same way. I would like to change the tires out to 10" versions for softer snow and more uneven grassy surfaces. The tires would probably come off of a hand truck but the axle on my board's trucks is 3/8's and I obviously need 5/8's. Has anyone here done this? Details would be awesome!
Thanks so much.
- Very Frequent Poster
- Posts: 562
- Joined: Wed Aug 28, 2002 1:00 am
I was the one that posted that. I had some customer 5/8 bearing spindles machined to fit over the ends of my MBS mountainboard to handle the larger 5/8 bearing diameter wheels you can buy at Home Depot for hand trucks. They are larger and wider, so the footprint is better for sand since the weight is distributed more evenly to the ground.
I had them custom made off some CAD drawings I made up. Using a setscrew to hold them in place and a nylon nut to hold the tires, just like the original nylon nuts.
They fit over the existing axle on each side, are about 5.5 inches long, and taper down to 5/8" for I think (from memory) 3" to allow the new tire to fit on.
It works really well. Give me a couple days and I'll put the graphic on the site. Let me know if you want me to do it by emailing me at the site.
Return to “Snow / Land”
Who is online
Users browsing this forum: No registered users and 3 guests