*


All times are UTC + 1 hour



Post new topic Reply to topic
 [ 3 posts ] 
Author Message
 Post subject: help!!!
PostPosted: Sat Feb 14, 2004 11:47 pm 
Offline
Frequent Poster

Joined: Sat Jul 26, 2003 6:35 am
Posts: 328
Location: Corpus christi
I found some fiberglass resin and hardener and thought I'd ask you guys if it would be a good resin for a laminated pine core board. Do you think I would need fiberglass cloth for reinforcement? Thank you for any help you might be able to give me!!!!


{ SHARE_ON_FACEBOOK } { SHARE_ON_TWITTER } { SHARE_ON_ORKUT } { SHARE_ON_DIGG } { SHARE_ON_MYSPACE } { SHARE_ON_DELICIOUS }
Top
Profile
 Post subject:
PostPosted: Sun Feb 15, 2004 12:24 am 
Offline
Medium Poster

Joined: Sat Jul 05, 2003 4:03 am
Posts: 182
Location: Little Cayman, Cayman Islands
I don't know much about builing ply boards but check out the post "first attempt" a couple of posts back. Some of the guys give good advice there.


Top
Profile
 Post subject:
PostPosted: Sun Feb 15, 2004 12:53 am 
Offline
Very Frequent Poster

Joined: Wed Nov 20, 2002 1:00 am
Posts: 880
Location: rhode island
hi,
there's not much point in using the resin if you dont use glass cloth.
a pine board around 1/2 - 3/4 inch thick should be strong enough without reinforcement.
paint or varnish will be alot less hassle.
-bill

if you have more questions take a peek at:
http://www.zeroprestige.org/
http://groups.yahoo.com/group/boardbuilding/


Top
Profile
Display posts from previous:  Sort by  
Post new topic Reply to topic
 [ 3 posts ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group