Here you can exchange your experience and datas about your home build boards
-
Windguy
- Frequent Poster
- Posts: 328
- Joined: Sat Jul 26, 2003 6:35 am
- Brand Affiliation: None
- Location: Corpus christi
-
Has thanked:
0
-
Been thanked:
0
Postby Windguy » Sat Feb 14, 2004 11:47 pm
I found some fiberglass resin and hardener and thought I'd ask you guys if it would be a good resin for a laminated pine core board. Do you think I would need fiberglass cloth for reinforcement? Thank you for any help you might be able to give me!!!!
-
CaymanWind
- Medium Poster
- Posts: 182
- Joined: Sat Jul 05, 2003 4:03 am
- Brand Affiliation: None
- Location: Little Cayman, Cayman Islands
-
Has thanked:
0
-
Been thanked:
0
Postby CaymanWind » Sun Feb 15, 2004 12:24 am
I don't know much about builing ply boards but check out the post "first attempt" a couple of posts back. Some of the guys give good advice there.
-
zfennell
- Very Frequent Poster
- Posts: 975
- Joined: Wed Nov 20, 2002 1:00 am
- Brand Affiliation: None
- Location: rhode island
-
Has thanked:
0
-
Been thanked:
0
Postby zfennell » Sun Feb 15, 2004 12:53 am
hi,
there's not much point in using the resin if you dont use glass cloth.
a pine board around 1/2 - 3/4 inch thick should be strong enough without reinforcement.
paint or varnish will be alot less hassle.
-bill
if you have more questions take a peek at:
http://www.zeroprestige.org/
http://groups.yahoo.com/group/boardbuilding/
Return to “Gear Builders”
Who is online
Users browsing this forum: No registered users and 203 guests