here you can exchange your experience and datas about your home build boards
- Very Frequent Poster
- Posts: 1478
- Joined: Wed May 21, 2003 12:07 pm
- Kiting since: 2002
- Style: If Ghengis Kan, I kan too!
- Gear: Grass fed Carbon Fiber
- Brand Affiliation: Peace in the Middle East
- Location: NW Pacific
I wanted a lightwind board with concavity so I took my 181 litewave and shortened it from 181 to 143 cm and filled the ends with epoxy
and fiberglass, then clamped the board on a stiff metal table with a piece of plywood under the center to get concavity and
stuck everything in a big cardboard box. I then put my propane weed
burner in the box and heated it up to about 200 degrees for an hour
or so. Took everything out and voila, a new board with 1/2" concavity
and much flatter.....Don't throw out that old board - modify it!
Pictures of the process....
- Medium Poster
- Posts: 72
- Joined: Thu Jun 19, 2003 8:19 pm
very cool, Could you give details on what exactly you used to heat your oven, and for that matter the oven itself. I tried using an electric blanket to take some excess rocker out of a board I made and I fucked up the board big time.
I'd like to make an oven to cure resin faster and harden paint
Return to “Board Builders”
Who is online
Users browsing this forum: No registered users and 6 guests