Forum for kitesurfers
-
phree
- Medium Poster
- Posts: 143
- Joined: Sat Dec 15, 2001 1:00 am
-
Has thanked:
0
-
Been thanked:
0
Postby phree » Thu Oct 03, 2002 1:05 pm
Anybody had to change out the X2 leading edge bladder yet? I've done plenty AR5 and ARX kind but not the X2. Anybody have pointers or whatever for this project?
-
Guest
-
Has thanked:
0
-
Been thanked:
0
Postby Guest » Thu Oct 03, 2002 4:52 pm
Check the instructions in the manual.
Remember to tie the rope at the end of the bladder before you remove it. It will save you time.
-
Guest
-
Has thanked:
0
-
Been thanked:
0
Postby Guest » Fri Oct 04, 2002 5:25 pm
It's not much different except for the bend in the wing tip requires a little attention. If you haven't noticed there is a small velcro opening in the corners that is just big enough to poke a finger in.
Stop pulling the string once the string was at the corner, open the velcro in the bend, use a finger to move the bladder past the corner, then pull the string the rest of the way.
The first time I tried I pulled the string off the bladder at the corner and I was pissed! I didn't know there was an opening in the corner, so when I discovered it I was quite relieved but it's quite small and a bitch to deal with. Luckily I was able to get at the bladder and reattach the string through the velcro in the corner.
Return to “Kitesurfing”
Who is online
Users browsing this forum: Abaltasis, Baidu [Spider], Bing [Bot], Brent NKB, Deaimel, Google [Bot], Guttorm, jjm, purdyd, SENDIT!, Trent hink, Xtream and 499 guests