Contact   Imprint   Advertising   Guidelines

Screws rule for making kiteboards

here you can exchange your experience and datas about your home build boards


User avatar
bay surfer
Very Frequent Poster
Posts: 889
Joined: Tue Dec 23, 2003 6:30 pm
Kiting since: 2001
Local Beach: The Dam Beach
Favorite Beaches: Lake Michigan Beaches, OCX
Gear: Airush, Best, LF boards, Home Brewed Foils and boards
Brand Affiliation: None
Location: Traverse City, MI usa

Screws rule for making kiteboards

Postby bay surfer » Sun Jul 24, 2005 3:48 am

I thought I post this for the Newbe board builders. One of the most easy way of laminating is using Drywall screws, whether a flat board or concave, rocker etc. Take a 3/4 in ply or chip board for the base and just screw the thin ply together to that board, just make sure you have wax paper under your thin ply. Rocker and fip tips just put a piece of wood at the ends of the board and screw down your ply. Concave slighty more conplex take a strip of wood down the center then put some thin ply on top for a jig table, then screw your ply down.

Screw holes are filled with Epoxy and wood dust/flour/microballons/etc
If your good you dont even see these holes once filled

Easy

Return to “Board Builders”

Who is online

Users browsing this forum: No registered users and 2 guests