I am considering a press. I would make the frame so it would be good for snowboards and kiteboards.
The only reason a snowboard press system is faster as you suggest is they use a silicone heat blanket right in the press. Nothing stopping you doing that with a vacuum setup either.
With medium speed resins a vacuum setup is fast enough and lends itself to changing all variables easily. Whereas a press you need to makes some VERY solid mold surface which keeps most small builders away.
i'm not using one myself, but am considering building one. the majority of the reading i've done is found on http://www.grafsnowboards.com. check out 'press' on the left hand side. a couple options to go by and some guidelines on how to get there.
Users browsing this forum: No registered users and 2 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum