Contact   Imprint   Advertising   Guidelines

Laminating multiple layers of foam for core?

here you can exchange your experience and datas about your home build boards

Rare Poster
Posts: 38
Joined: Sat Feb 02, 2008 6:10 pm
Kiting since: 2007
Local Beach: New Hampshire/Vermont
Favorite Beaches: Key West, Lake Michigan
Style: Learning
Gear: LF Havoc 14, 8, Eclipse Nano 6
Brand Affiliation: None
Location: Lebanon, NH

Laminating multiple layers of foam for core?

Postby stvandev » Thu Jul 24, 2008 3:18 am

So I've built a couple of plywood boards now and thinking of trying a foam core. I built my ply boards with two layers of 6mm ply laminated with epoxy. I put the rocker into the boards during laminating by placing weight on the top with the tips propped up to the wanted height, and they held the shape with very little spring back. I glassed both sides after that. Is it possible to use this process with a foam core? I was thinking about laminating 2 layers of 6mm Divinycell. I'd prefer to hand-layup the boards and not use a vaccuum. The biggest issue that I've come up with this approach assuming it works is how and when to attached the rails. Anyone have ideas?

Any suggestion for an online source for strips of ABS for rails if I decide to go that route?

On another different note anyone have a good online source for paulownia or balsa wood for cores?


Rare Poster
Posts: 12
Joined: Tue Jun 17, 2008 9:43 pm
Kiting since: 2003
Local Beach: Cocoa Beach, FL
Favorite Beaches: Ann's Beach, Islamorada, FL
Style: Wake
Gear: 2007 Underground 138,
7,9,11,13,15,17 SS Fuel kites 2005
Brand Affiliation: None

Re: Laminating multiple layers of foam for core?

Postby pranaboard » Thu Jul 24, 2008 3:39 am

I found that link very helpfull

Return to “Board Builders”

Who is online

Users browsing this forum: No registered users and 3 guests