..it was! one of the shapping stages was leaving it outside at nigth ....BWD wrote:I like the paint job -looks like the board has been attacked by zombies, with only minor damage!
exactly... but since it'll be very hard to get some, i'm going to add a middle box and add the option to try my windsurfing fins like this:BWD wrote:IF you have the chance, try it with some good fins before you get rid of it I guess.
its not sharp at allgbleck wrote:My guess whould be the rail shape from the mid line back isn't sharp enough. Try and mix up some epoxy and thickening agents and sharpening up the rails or maybe cut down from the top and reshape them to a 90deg vertical flat off the bottom.
sorry no details, I just cut the bottom part of the yellow ones and the top of the black.... ( were cheap ws fins) I think the higher the aspect ratio the bettergbleck wrote: if you have an details on how you made the fins. Built a cheap mini tuttle box out of maple I had laying around. Have to make up the fin and it's all set. Going to start off as a single fin and maybe add little thrusters on the sides later if I need them.
Users browsing this forum: No registered users and 2 guests