here you can exchange your experience and datas about your home build boards
- Rare Poster
- Posts: 12
- Joined: Sun Dec 20, 2009 12:13 am
- Kiting since: 9
- Local Beach: bahia salinas costa rica
- Brand Affiliation: None
I've been thinking to use a plotter to cut graphics for a board ...they look great ...but I'm affraid the material for the stickers won't adhere to the epoxi ...and eventually delaminate .
what is the best material for graphics to place under glass? I've heard of rice paper ...very thin almos transparent, but how do you print on that ??
can you use other types of paper?? I live in Costa Rica and the variety of resourses here are limited...
I need some ideas !! Suggestions?
- Frequent Poster
- Posts: 437
- Joined: Tue Feb 24, 2009 1:43 pm
- Kiting since: 2006
- Local Beach: Grado Pineta (IT), Fossalon (IT)
- Style: Freeride, strapless hooked-in
- Gear: FS S3 19m2 DLX
FS S3 CE 12m2 DLX
FS S4 8m2 DLX
Homemmade Alaias, TTs and wake skate, Naish Mutant 5´5½
Aboards Reverse 161 cm
Homemade POW SB 166 x 32,5 cm
Flow NX2 SE
- Location: Iv.G.-Slovenia
yes, the rice paper. When you soak it with epoxy it will become transparent. Yust put it underneath the glass-fibre cloth layers, so you don't sand it later, it will be visible very good.
I printed only smaller pictures. I taped rice paper on the edges to a harder paper.
Return to “Board Builders”
Who is online
Users browsing this forum: No registered users and 2 guests