swim82 wrote:mthboards wrote:I put the glass down then put one good sanding coat on it and almost sand it down to the glass with 60 grit. Then I put an extremly thin finish coat of polyurothane just to get ride of the scratches.
Then its 800 grit then 2000 grit, then rubbing compound then polishing compound takes me a good 4 hours to do both sides. http://WWW.MTHBOARDS.COM
really nice board, I just started making a cedar board
how do you make you rocker hold with the full glass boards?
do you put a strip of glass running the whole lenght but just in the middle while holding the sides to the rocker table with clamps? if so, do you glass over the strip after?
second question, how much more rocker do you put in ceder to get the rocker you want? for example, do you glass witha 2 inch rocker to get a one inch rocker once you unclamp it?
Users browsing this forum: No registered users and 5 guests