Hello
I'm building my first kiteboard, and i need your opinion.
This is the model of core. I 'm planing on making core from one piece of wood. I'm deciding between oak, beech wood, and maple.
Uploaded with ImageShack.us
The board core is 44 cm wide and 139 long. The tips and edges are 3mm thick and the middle rose section is 10mm thick. It will have1.5 - 2 cm rocker and 3.5mm concave.
I'm thinking of using two sheets of fibreglass (+ graphic sheet) on each side.
200 g/m2 + 236 (74+78+74+10) g/m2 three-axial. Combined 436 g/m2 (15.3 oz)
I'm wondering if that is fine since i'm using wooden core, or would 100 g/m2 + 236 (74+78+74+10) g/m2 three-axial combination (336 g/m2 or 12 oz) bi just as fine.
I' will be using vacuum baging.