Billy B. wrote:Any one know the foot strap screw size on Alex's race boards I am short one and the hole it goes into is already "tapped" to this size, I can't find a US size match and would love to find the correct size so I can order a couple online...
Any help would be great?
Thanks.
Message subject: Re: Screw size for foot straps??
Folder: Outbox
Hi Billy,
I am assuming you have the Production board? If so, it is a close version of the #12x 1" sheet metal screw in Stainless steel. I have a Metric version of this screw that is similar packaged with these boards. It might be a little tight with the #12 when first tightening it but should be OK.
If it is a custom raceboard that I made then the size is #10x 1" sheet metal screw in Stainless steel.
If it is a production raceboard that was built in Vietnam then you can use the #10x1" also , but if it is too loose switch to the #12x1" Sheet metal screw in SS.
Do not put a screw longer than 1 inch in either style of my raceboards because it will bottom out.
.
Let me know if this helps!
AA