140 X 41
H80 24 oz. top and bottom
1.75" Rocker
2 mm ellipticle concave (None in tip and tail)
Cast rails

http://www.facebook.com/photo.php?fbid=1287005951132&set=a.1018218351610.2837.1709672325&theater

Nice board How did you build it? Wood core?

Nice look. Cast epoxy rails or high density poly urithane? I love the graphics. Some sort of printed plastic or less exotic?

This one is Just a Divincell H80 3/8" Foam Core. I have done wood cores and Hybrid wood/foam and they are all made the same. Cast epoxy and Micorpheres for the rails. Graphix... vehicle wrap. I also have the same place print graphix on cotton for layup under my fiberglass but this one is just wrapped and then clearcoated.

nice board brah. similar to a brokite but with fancy graphics.

How did you do the rails? I'm building a board right now and I'm not totally sure on the rails. I'm building a carbon board and want to make a poured epoxy rail for it, like you did. When I cut out the woodcore I'll save the "left over wood" and use it as a mould. I'll then cut of 0,5mm of the board and then fill the gab with epoxy. So I think, I got that covered. But afterwards what then? Can I just cut of the rest of the carbon and sand it down to make a smooth rail?