Here's another sample....I tested the a proto mount for Stringy about 4 months ago...great product.
Stringy or Ryan...was the angle of the mount changed from the proto I used or were any of the other videos shown on this thread edited to adjust? R4 refers to the GoPro setinghttp://www.vimeo.com/20119535
I tried to maintain as much through the development of the mount prototypes to the final production design.
Angle is virtually the same, but depending on your board's nose rocker, this could affect angle of perspective. Not an issue though because the camera captures quite a bit in this configuration.
There are some changes due to manufacturing issues, but overall this mount is how I wanted it to be.
with the production mounts being made of glass filled nylon, the likelihood of failure is going to be extremely low on this mount system.
Here is an uncropped image from using the new fin mount I took last week.