Post subject: My First try at a Carbon & Fomie Board.
Posted: Sat Jan 21, 2012 5:03 pm
Very Frequent Poster
Joined: Sun Sep 04, 2011 5:37 pm Posts: 1895
This was my Second board ; the first one was the same design but made of 1/2" Basswood Ply. It was a 158 X 48. I cut it a bit large & tossed it into a Hot jacuzzi for the night, then braced it up on a jig and let it dry slowly. It was Heavy. So i made a rocker table mold & built a carbon & 3lb density foam one. it was kinda OK light, till i learned to jump, that's when i found out about extra shear-web under the heal.
It is still my favorite board in light wind cause i can ride it flat & still upwind ; because of the fin array on the heal-side. Turns out I Needed them when first learning to ride with the prosthetics. All my balance comes from sheeting.
I've ridden it in a 40mph with my 10m PL venom.
I first tried to learn a back-roll on it but couldn't till going down in size to a 142 Underground. Even on the Underground i need a variation on the same fins. I use (4), 2" Dolphin at the normal spots but on the Heal-side i placed a 1.5" X 5" long fin, in front of & to the rail side of the Dalphin. It grips Well. Too well for a lighter than 212lb rider like me -- but again i Need the resistance with the fake-legs. I took a Bunch to learn to ride on the double prosthetic ; things like Pidgin-tow instead of a Duck stance (exc...
UAH -- it's OK to Laugh -- it was my First try at a molded board & i learned a Lot !! Made it in 2005 . I lost ALL of 2008 in a wheel-chair & started boarding again in the winter of 2009 .
Copy of Mid basin 5.JPG [ 124.07 KIB | Viewed 1262 times ]
Last edited by Bille on Sat Jan 21, 2012 10:42 pm, edited 1 time in total.
Users browsing this forum: No registered users and 5 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum