Okay, I've finished my rocker table, the surface is 1/4" mdf, just put the final touches on my vacuum pump, works like a charm, cut out my template and now, I'm ready to build my light wind machine, 146x46 My thoughts were as follows;
1/4" dyvinacel core with the perimeter routed out and poured PU rails or epoxy with micro balloons poured as rails,
An added 1/4 deck that tapers to the edges for added firmness with 4 oz glass sandwiched between
A layer of 6 oz e glass ( is s glass that much better for my first board) followed by 2 - 4 oz layers on either side of the core.
All this layed up on a sheet of Mylar and vacuum bagged.
Not sure about the top sheet, might try to find some cotton print for the first board. Also probably going to use a tint for the bottom, so it'll just be a solid yellow or orange.
With this be okay?. To think, to thin?. Any thoughts.
Thanks,
I'll post pics as things progress.